11 14 015 Removing and installing/replacing sealing cap for oil pump chain tensioner (N55)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary work:

Remove FAN COWL .
Remove DRIVE BELT for alternator.
Remove both drive belt TENSIONING DEVICES (hybrid car).
Remove VIBRATION DAMPER .

Drive out sealing cap (1) with a suitable punch (2) in direction of arrow.

NOTE: The sealing cap is driven out diagonally during this operation.

Fig 1: Removing Sealing Cap

G10041875

Courtesy of BMW OF NORTH AMERICA, INC.

Removing sealing cap:

Prepare special tool 11 8 530 .

Remove special tool 11 8 533 from special tool 11 8 532 and 11 8 534 .

Special tool 11 8 536 is not required.

Fig 2: Identifying Special tool 11 8 536

G10041876

Courtesy of BMW OF NORTH AMERICA, INC.

Special tool 2 318 118 is magnetic.

Secure special tool 2 318 118 on special tool 11 8 531 (refer to Fig 3).

Fig 3: Identifying Special Tool 2 318 118

G10041877

Courtesy of BMW OF NORTH AMERICA, INC.

Screw back screw (2) on special tool 2 318 119 .

Install special tool 2 318 119 with screw (1) on special tool 11 8 531 .

Fig 4: Identifying Special Tool 2 318 119

G10041878

Courtesy of BMW OF NORTH AMERICA, INC.

Position sealing cap (1) on crankcase (2).

Fig 5: Positioning Sealing Cap On Crankcase

G10041879

Courtesy of BMW OF NORTH AMERICA, INC.

Installing sealing cap:

Screw in screw (1) on special tool 2 318 119 up to limit position.

Tightening torque 20 Nm.

Fig 6: Installing Sealing Cap Using Special Tool 2 318 119

G10041880

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.