41 33 040 Replacing Front Wall

Following new body parts are required :

• Connection, front end/side frame
• Mounting, bumper, front middle
• Holder, side panel, bottom left
• Holder, front wall, left
• V-support
• Holder, front wall, right
• Holder, side panel, bottom right
  Fig 1: Body Parts Components

  Courtesy of BMW OF NORTH AMERICA, INC.

Open screws (1).

Fig 2: Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Open screws along line (1).

Remove front end/side frame connection (2).

Fig 3: Open Screws Along Line

Courtesy of BMW OF NORTH AMERICA, INC.

Open screws (1) and (2).

Remove front middle bumper mounting (3) and V-support (4).

Fig 4: Front Middle Bumper Mounting, V-Support And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Drill out rivets (1).

Open screws (2).

Remove carrier for bumper trim with deformation element (3).

Remove front wall holder (4).

Installation: 

If necessary, use screws or locking pins (instead of rivets) to secure deformation element.

Fig 5: Drill Out Rivets And Screws

Courtesy of BMW OF NORTH AMERICA, INC.