22 31 005 Removing and installing/replacing transmission support bracket
Necessary preliminary tasks:
- Clamp off BATTERY
- Remove intake silencer housing. See 13 71 000 REMOVING AND INSTALLING THE INTAKE SILENCER HOUSING (N16) or 13 71 000 REMOVING AND INSTALLING/REPLACING THE INTAKE SILENCER HOUSING (N14, N18) .
- Remove CONTROL UNIT
- Support engine/transmission with car jack
Remove lid of fuse box.
Release screws (1).
Push fuse box to one side.
Tightening torque 61 13 1AZ .
Release screws (1).
Remove holder (2).
Release screws (1).
IMPORTANT:
Screws M10 8.8 must
be replaced by screws M10 10.9.
Replace screws and nuts.
Tightening torque 22 32 2AZ .
Slacken nut (2).
Tightening torque 22 32 3AZ .
Remove transmission support bracket.