11 22 500 Removing and installing or replacing flywheel (N16)
Special tools required:
Necessary preliminary tasks:
- Remove transmission. See 24 00 031 REMOVING AND INSTALLING TRANSMISSION (AUTOMATIC) or 23 00 026 REMOVING AND INSTALLING TRANSMISSION (MANUAL) .
- Remove CLUTCH .
Lock flywheel with special tool 11 9 590 .
Flywheel for automatic transmission:
Release flywheel bolts (1).
Tightening torque: 11 22 1AZ .
Installation note:
Flywheel (1) is secured with an dowel pin.
Fit new flywheel bolts.
Clean crankshaft thread for flywheel bolts.
Flywheel for manual transmission:
Flywheel with and without dual-mass: unscrew bolts (1).
Installation note:
Flywheel is secured with a dowel pin.
Fit new flywheel bolts.
Tightening torque: 11 22 2AZ .
Installation note:
Reluctor ring (1) is loose on crankshaft and is only held in place when the flywheel is fitted.
Dowel pin (2) for fixing reluctor ring/flywheel.
Assemble engine.