34 00 025 Replacing fluid in DSC brake system

NOTE: Read and comply with GENERAL INFORMATION .

IMPORTANT: When carrying out repairs to the brake system, follow the procedure set out in BLEEDING BRAKE SYSTEM WITH DSC .

Always use MINI-approved brake fluids, refer to MINI OPERATING FLUIDS .

Open cover (1).

Connect bleeder unit to expansion tank (2) and switch on.

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.

Fig 1: Identifying Expansion Tank And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Completely bleed the brake system.

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Follow same procedure on rear left, front right and front left wheel brake.

Fig 2: Locating Bleeder Valve On Rear Right Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The CLUTCH SLAVE CYLINDER must be scavenged in cars with manual transmissions.

Switch off bleeder unit and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to max. level.

Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.

Fig 3: Identifying Rubber Seal In Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.