11 28 050 Replacing A/C compressor drive belt with belt tensioner (N63O1)

WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Risk of damage!
Release screws (1) on vibration absorber only if removal position is adjusted.
If contaminated with hydraulic fluid: Replace drive belt.
Crank engine at central bolt in direction of engine rotation.

Installation note:

If the drive belt is to be reused, mark direction of travel and reinstall drive belt in same direction of rotation.

Necessary preliminary work:

Remove DRIVE BELT for alternator.

NOTE: Observe direction of engine rotation.

Crank engine at central bolt until marking (see arrow in illustration) is reached on vibration absorber.

Release screws (1).

Tightening torque 11 28 2AZ .

Fig 1: Identifying Screws And Marking On Vibration Absorber

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Belt pulley is pretensioned.
Belt pulley tension is relieved abruptly during the cranking process!

NOTE: Observe direction of engine rotation.

Crank engine at central bolt until marking (see arrow in illustration) is reached on vibration absorber.

Remove elasto-belt.

Fig 2: Identifying Vibration Absorber In Position To Remove Elasto-Belt

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.