31 21 088 Removing and installing left or right swivel bearing (all-wheel drive vehicle)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2018 BMW M6, 2018 BMW 650i xDrive, 2018 BMW 650i, 2018 BMW 640i xDrive, and 2018 BMW 640i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT WHEEL .
Release collar bolt (1), press brake pedal to floor for this purpose.
Tightening torque 31 60 2AZ .
Installation note:
- Replace collar bolt (1) and compression spring (2).
- Pay attention to direction of installation of compression spring!
- Keep collar bolt and spur gearing of bearing/output shaft clean and free of grease.
IMPORTANT:
See installation note on spur gear.
IMPORTANT:
Secure swivel bearing against falling out.
- Remove BRAKE DISC .
- Expose brake hose and cable on swivel bearing.
- REMOVE pulse sensor from swivel bearing.
- REMOVE lower wishbone from swivel bearing.
- REMOVE trailing link from swivel bearing
- REMOVE track rod end from swivel bearing.
- Remove . See 31 12 002 REMOVING AND INSTALLING/REPLACING TOP LEFT WISHBONE or 31 12 003 REMOVING AND INSTALLING/REPLACING TOP RIGHT WISHBONE (M6) upper wishbone from swivel bearing.
Remove swivel bearing.
IMPORTANT:
Note on installation for spur gearing must be observed without fail!
Installation note:
- Spur gearing of bearing (1) and output shaft (2) must be installed form-fit (tooth in tooth)!
- Tighten collar bolt and compression spring by hand.
- Check whether spur gearing is locked tooth in tooth by reciprocally rotating wheel hub/output shaft.
- Once a form-fit has been ensured, tighten to final torque.
Tightening torque 31 60 2AZ .