41 14 021 Filling Bulkhead Cross-Member With Foam

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

For acoustic insulation reasons insulating foam is applied to the finish-painted bodyshell in the bulkhead cross-member area.

A 2-component PU cavity foam is used.

Observe safety and application instructions.

Auxiliary equipment:

To perform the operation, it will be necessary to lengthen the spray pipe as pictured.

Spray pipe
Extension hose, approx. 150 mm long

Mark extension hose according to specified measurements.

Measurement a = approx. 15 mm

Measurement b = approx. 120 mm

Fig 1: Identifying Extension Hose According Mark To Specified Measurements

Courtesy of BMW OF NORTH AMERICA, INC.

Filling cross-member with foam:

Carry over the work step shown symmetrically to the other side of the vehicle.

Insert extension hose through opening (1) up to marking length b.

Spray cavity foam for approx. 10-15 seconds uniformly into cross-member. In so doing, slowly pull out spray pipe up to marking length a.

IMPORTANT: Empty the can within 8 minutes.
Follow manufacturer's safety instructions.

Fig 2: Inserting Extension Hose Through Opening Up To Marking Length B

Courtesy of BMW OF NORTH AMERICA, INC.