11 25 Pistons with Rings and Pins
NOTE:
For diameter of cylinder bore, refer to ENGINE BLOCK .
PISTONS WITH RINGS AND PINS SPECIFICATION - 1 OF 2
| 1st groove | ||
| End clearance | mm | 0.20... 0.40 |
| End clearance (wear limit) | mm | 0.91 |
| Side clearance | mm | 0.015... 0.060 |
| 2st groove | ||
| End clearance | mm | 0.30... 0.55 |
| End clearance (wear limit) | mm | 1.06 |
| Side clearance | mm | 0.015... 0.060 |
| 3rd groove | ||
| End clearance | mm | 0.10... 0.40 |
| End clearance (wear limit) | mm | 0.82 |
| Side clearance | mm | 0.040... 0.10 |
PISTONS WITH RINGS AND PINS SPECIFICATION - 2 OF 2
| Piston and pin are paired to each other - replace together only. | ||
| Measuring point "A" (position) | mm | 10 |
| Piston diameter at measuring point "A" | ||
| Original (new dimension) | mm | 76.949... 76.967 |
| Piston running clearance | mm | 0.033... 0.067 |
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.10 |