11 14 005 Replacing front crankshaft radial seal (N16)

Special tools required:

IMPORTANT: PTFE ring is supplied with a support disc.
Supporting ring is required as an installation tool.
Do not touch inner sealing face of PTFE ring with fingers (risk of damage ).

Necessary preliminary tasks:

Remove VIBRATION DAMPER .
Disconnect REFRIGERANT LINES from air conditioning compressor.

IMPORTANT: Do not release central bolt.

If the central bolt is released, the sprockets of the timing chain and the oil pump will no longer be non-positively connected to the crankshaft. The camshafts will be able to rotate relative to the crankshaft (risk of damage ).

Fig 1: Caution For Central Bolt

G04751061

Courtesy of BMW OF NORTH AMERICA, INC.

Drive PTFE ring inwards with a punch (1) until PTFE ring tilts outwards at bottom.

IMPORTANT: PTFE ring can slip inwards.

Fig 2: Installing PTFE Ring Using Drift

G04796179

Courtesy of BMW OF NORTH AMERICA, INC.

Attach special tool 11 9 601 to crankshaft using bolts (1) tightened to 15 Nm.

Fig 3: Securing Special Tool (11 9 601) To Crankshaft Using Screws

G04796180

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Apply a thin coating of oil to special tool 11 9 601 .

Position PTFE ring (2) and supporting disc (1) on special tool 11 9 601 .

Push PTFE ring (2) over support disc (1) in direction of arrow up to crankcase.

Fig 4: Pushing PTFE Ring Over Supporting Ring

G04796181

Courtesy of BMW OF NORTH AMERICA, INC.

Remove supporting disc from special tool 11 9 601 .

NOTE: Support disc is no longer needed.

Fig 5: Removing Supporting Ring From Special Tool (11 9 601)

G04796182

Courtesy of BMW OF NORTH AMERICA, INC.

Pull in PTFE ring using special tool 11 9 602 in conjunction with special tool 11 9 603 until flush.

Fig 6: Installing PTFE Ring Using Special Tool (11 9 602)

G04796183

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.