51 45 050 Removing and installing dashboard upper section trim

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

Release top screws (1).

Fig 1: Identifying Top Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) from middle of fresh air grille (1) at left and right.

Unlock and feed out middle of fresh air grille at left and right (1) by twisting.

Release screws (3) from function carrier (4).

Fig 2: Removing Middle Of Fresh Air Grille At Left And Right

Courtesy of BMW OF NORTH AMERICA, INC.

Release remaining screws (1) from function carrier (2).

Feed out the function carrier (2) and place to one side.

Installation note:

Make sure wiring harnesses are laid correctly.

Fig 3: Identifying Function Carrier And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (3) on retaining bracket of front passenger airbag module (2).

Tightening torque 72 12 7AZ .

Unfasten plug connection (1) and disconnect.

Unclip counterpart of plug connection (1) from retaining bracket of front passenger airbag module (2).

Fig 4: Identifying Front Passenger Airbag Module Retaining Bracket, Screws, And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) on trim panel of top part of dashboard (2) at right.

Feed out and remove trim panel of top part of dashboard (2) from dashboard support.

Fig 5: Identifying Screws On Dashboard Top Part Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.