12 41 020 Removing and installing/replacing starter (N18 AWD)

Necessary preliminary work:

NOTE: For a better overview, the following operation is shown on the engine after it has been removed.

Release screw.

Tightening torque 12 41 1AZ .

Fig 1: Locating Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release connector (1) and remove.

Release nut (2) and remove the positive battery cable.

Tightening torque 12 41 2AZ .

Release screws.

Tightening torque 12 41 1AZ .

Remove bracket (3) and starter from the top.

Fig 2: Identifying Connector, Holder And Cable Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Install starter motor and fit screws.

Press starter motor (1) in direction of arrow and tighten down.

Fig 3: Installing Starter Motor

Courtesy of BMW OF NORTH AMERICA, INC.