65 77 604 Replacing sensor mat (CIS mat) for front passenger seat occupancy detector
WARNING:
Comply with AIRBAG SAFETY INFORMATION
.
Incorrect handling can activate airbag and cause injury.
Incorrect handling can activate airbag and cause injury.
WARNING:
Only US and Canadian version of front passenger seat (with CIS mat):
The CIS mat is bonded to the entire surface of the facing and can only be removed in conjunction with the padding from the seat cover.
If CIS mat or padding is defective, both parts may only be replaced together.
Full functional capability can only be guaranteed with original BMW spare parts.
After installation, the CIS mat must be enabled with the BMW PROGRAMMING SYSTEM .
The CIS mat is bonded to the entire surface of the facing and can only be removed in conjunction with the padding from the seat cover.
If CIS mat or padding is defective, both parts may only be replaced together.
Full functional capability can only be guaranteed with original BMW spare parts.
After installation, the CIS mat must be enabled with the BMW PROGRAMMING SYSTEM .
Procedure for replacing the CIS mat together with the upholstery is described in:
- Remove SEAT COVER for front seat
The work scope with CIS mat is different for the following work steps:
Cut open cable strap (1).
Installation note:
Replace defective cable strap.
Raise tab and pull connector from connector housing.
Enabling seat occupancy detector (CIS mat):
- Connect BMW PROGRAMMING SYSTEM
- Code airbag control unit
- Delete fault memory if necessary