00 00 251 Engine oil service including additional service (W10/W11)

Recycling: 

Catch and dispose of used oil in a suitable container.

Observe country-specific waste-disposal regulations.

Remove oil filter housing (1).

Tightening torque, refer to 11 42 3AZ in ENGINE - TIGHTENING TORQUES - COOPER & COOPER S (1.6L) R50/W10 .

Fig 1: Removing Oil Filter Housing

Courtesy of BMW OF NORTH AMERICA, INC.

1. Oil filter element MINI ONE and MINI COOPER (W10) up to now  .
2. Replacement oil filter  for all  MINI ONE and COOPER (W10) and MINI COOPER S (W11) engines

Installation: 

The new oil filter element (2) must be fitted in the (W10) engines with a higher amount of force.

The inside diameter is somewhat narrower and slightly higher so that increased pressure is needed to refit the oil filter cap.

Fig 2: Identifying Types Of Oil Filter Elements

Courtesy of BMW OF NORTH AMERICA, INC.

1. Filter housing cap.
2. Spring.
3. Plastic guide sleeve.
4. Oil filter element.

Fig 3: Identifying Oil Filter Element Parts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

MINI COOPER S (W11) oil filter housing cap (1) without guide sleeve and spring.

Fig 4: Identifying Oil Filter Housing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace filter element and sealing ring.

Detach filter element from oil filter cap.

Press in a new filter element.

Apply a light coating of engine oil to sealing ring.

Fig 5: Replacing Filter Element And Sealing Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Remove oil drain plug (1).

Tightening torque, refer to 11 13 1AZ in ENGINE - TIGHTENING TORQUES - COOPER & COOPER S (1.6L) R50/W10 .

Installation: 

Replace screw with seal.

Fig 6: Removing Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine. 

Refer to ENGINE - TECHNICAL DATA - COOPER & COOPER S (1.6L) R50/W10 .

Check filter housing and oil drain plug for leaks.