Drive Axle Shaft (Right): Installation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
Replace collar nut. Secure collar nut after tightening by peening on flat area. See TORQUE SPECIFICATIONS . Replace self-locking nut. Replace self-locking nuts. Replace circlip. See Figure . Position Special Tool (284 120) on shaft seal as shown. See Fig 1 . Ensure tool fits over the sealing ring lip so sealing ring is protected when drive shaft is inserted. Make sure the tool is properly guided over the sealing ring lip. Insert drive shaft in seal as shown and remove Special Tool (248 120) by pulling handle. See Fig 2 . Push drive shaft over resistance of snap ring. The drive shaft must snap audibly into place. Add transmission oil and check for leaks.