34 00 025 Replacing fluid in DSC brake system

NOTE: Read and comply with GENERAL BRAKE SERVICE INFORMATION .

IMPORTANT: When carrying out repairs to the brake system, follow the procedure set out in BLEEDING BRAKE SYSTEM .

Always use MINI-approved brake fluids, refer to OPERATING FLUIDS .

Open cover (1).

Connect bleeder unit to expansion tank (2) and switch on.

IMPORTANT: Check relevant equipment manufacturer's operating instructions for each device.
Charging pressure should not exceed 2 bar.

Fig 1: Identifying Expansion Tank And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Completely bleed the brake system .

Connect bleeder hose with collecting tray to bleeder valve on rear right brake caliper.

Open bleeder valve and purge until clear, bubble-free brake fluid emerges.

Close vent valve.

Follow same procedure on rear left, front right and front left wheel brake.

Fig 2: Locating Bleeder Valve On Rear Right Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The clutch slave cylinder must be scavenged in cars with manual transmissions.

Switch off bleeder unit and remove from expansion tank.

Check brake fluid level. If necessary, top up/draw off to max. level.

Close expansion tank.

NOTE: Pay attention to rubber seal (1) in sealing cap.

Fig 3: Identifying Rubber Seal In Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.