63 12 010 Removing and installing (replacing) (Xenon) headlight
WARNING:
Danger to life due to high voltage. Therefore, before removing, disconnect all components from the voltage supply (lighting system and ignition off).
Work on the entire xenon lighting system (ignition device, control unit and bulb) may only be carried out by qualified technicians.
Follow instructions for HANDLING LIGHT BULBS (EXTERIOR LIGHTS) .
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Release screws (1). Tightening torque 63 12 1AZ .
Disconnect plug connection (2).
Pull headlight forwards slightly and disconnect hose connection (3) from high-pressure nozzle (4).
Remove headlight.
Installation note:
Adjust GAP DIMENSIONS by means of adjusting screws (1)
Adjust HEADLIGHTS
Replacement:
- Modify XENON BULB FOR HEADLIGHTS
- Modify BULB FOR TURN INDICATOR
- Modify CONTROL UNIT FOR XENON HEADLIGHT .
- Modify HIGH-PRESSURE NOZZLE of headlight cleaning system
- Modify adjusting screws