12 63 586 Replacing power distribution box

Attention!

Necessary preliminary tasks:

Removal:

Release lock (1).

Detach cable (3) from equipment holder (4).

Carefully pull out power distribution box (2).

Fig 1: Power Distribution Box, Equipment Holder, Cable And Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and pull off.

Remove power distribution box (2).

Fig 2: Power Distribution Box And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Connect the connector (1) to the power distribution box (2).

Connectors (1) must engage audibly.

Fig 3: Power Distribution Box And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Route cable (3) in the equipment holder (1).

Push the power distribution box (2) into the equipment holder (1) and snap into place.

Fig 4: Power Distribution Box, Equipment Holder And Cable

Courtesy of BMW OF NORTH AMERICA, INC.