41 14 502 Rear Left Outer Wheel Arch Section Replacement (Rear Left Side Panel Removed)
Spot-weld bonding is used on the E60. Observe specific procedure .
Following new body parts are required:
- Wheel arch, outer, rear
- C-pillar, inner
Courtesy of BMW OF NORTH AMERICA, INC.
Mark severance cut (1) in accordance with measurement and cut.
Water drainage hose (2) of sunroof is located behind severance cut (1).
Measurement a = approx. 30 mm from side panel cut.
Remove cavity bulkhead (3).
Open weld joints in areas (4).
Installation information:
- Apply window glass adhesive to cavity acoustic baffle (3).
Installation:
Make a metal angle bracket (1) to protect water drain hose against welding heat. Length a = 30 mm. Fit metal angle (1) on hose and secure centrally under cutting edge through welding spots.
Open weld joints in area (1).
Remove front C-pillar reinforcement (2).
Mark severance cut (1) in accordance with measurement a and cut.
Measurement a = approx. 200 mm from roof edge.
Open weld joints in areas (2).
Installation:
Mark severance cut (1) on new part in accordance with vehicle and cut.
Insert reinforcement plate at severance cut.
Cut wheel arch along line (1).
Preparation of new part:
Mark new part in accordance with severance cut on vehicle + 20 mm extra material and cut (1).
Cut wheel arch along line (1).
Cut outer metal sheet only.
Open weld joints in areas (2).
Installation:
Adjust new part in conjunction with side panel to fit.