41 63 003 Cover Bowl Replacement

Necessary preliminary tasks: 

• Remove flap for fuel filler neck  . 
• Remove servodrive for tank filler flap  . See 67 11 555 REMOVING AND INSTALLING/REPLACING SERVODRIVE FOR TANK FILLER FLAP .

Turn cover (1) through approx. 45° and lever out in direction of arrow.

Fig 1: Turning Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove rubber pad (3).

Press retaining strap (1) inwards and remove.

Remove cover (2).

Lever out seal (4) inwards.

Insert a suitable tool through bores (3) and release catches.

Installation: 

Make sure seal (4) is correctly seated.

Fig 2: Pressing Retaining Strap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Catches (1) on ejector (2) must not be damaged.

Check protective cap (3) for correct seating.

Fig 3: Catches, Ejector And Protective Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Locks (1) on left/right of cover (2) must not be damaged.

Fig 4: Locks And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Close flap (1).

Twist cover bowl (2) in direction of arrow out of side panel and remove.

Fig 5: Twisting Cover Bowl

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Following parts on cover bowl (6) must not be damaged or missing:

1. Rubber pad
2. Catches, top/bottom
3. Spring
4. Catch
5. Guide
   Fig 6: Identifying Rubber Pad, Catches Top/Bottom, Spring, Catch And Guide

   Courtesy of BMW OF NORTH AMERICA, INC.