41 61 000 Engine Hood Removal And Installation
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Support engine hood in fully opened position with suitable apparatus. Risk of injury.
NOTE:
Carry over schematic representation to the relevant vehicle type.
Loosen screws (1).
Unfasten screws (2).
Remove hood lid.
Installation:
Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust engine hood .
Tightening torque, see 41 61 1AZ in 41 61 ENGINE BONNET/HOOD