4162000 Removing And Installing Rear Lid
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Read general service information under BODY .
Necessary preliminary tasks:
- Remove PANEL FOR REAR LID
- Disconnect all plug and socket cable connections on rear lid.
Carry over the work step shown symmetrically to the other side of the vehicle.
Slacken screws (1)
Unfasten screws (2).
Tightening torque 41 62 1AZ .
Remove rear lid.
Installation:
Adjust REAR LID .