4161014 Adjusting Engine Compartment Lid

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Read general service information under BODY .

The specified BODY GAP DIMENSIONS serve as the basis for adjustment tasks.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: Carry over schematic representation to the relevant vehicle type.

Loosen screws (1) and (2) on left and right hinges.

Hood lid must be able to be moved.

NOTE: If the adjustment range is not sufficient, release retaining screws of engine hood hinge on body and move hinge.

Fig 1: Identifying Hood Hinge Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Locks and retaining hook must snap correctly into place.

Adjust engine hood.

NOTE: VERTICAL ADJUSTMENT of engine hood to side panel by means of stop pads.

Fig 2: Locating Engine Hood/Bonnet Adjustment Area

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Height adjustment of bonnet to front wall:

Release screw (1) and remove cover (2).

Height adjustment by turning at closing hooks (3).

Fig 3: Identifying Cover, Hooks And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down all screw connections again.

Tightening torque 41 61 1AZ .

IMPORTANT: Check function of retaining hook.