Preparation Of New Part
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
Slide in rear trim panel (1) from bottom upwards.
Adjust in combination with tailgate and rear lights to fit and secure.
IMPORTANT:
Retaining screws must not be used in area (1)
In areas (2 to 5) set 4.2 mm dia. holes for blind rivets N3:
SCREW MOUNTING AREA REFERENCE CHART
| Area | Number |
|---|---|
| 2 | 1 |
| 3 | 2 |
| 4 | 3 |
| 5 | 2 |
Remove new part and deburr bore holes.
IMPORTANT:
Do not grind/sand new part in area of bonding surfaces.