Installation Note

Adjust new parts to fit with alignment bracket or universal mount and secure.

Fig 1: Identifying Alignment Bracket Or Universal Mount

Courtesy of BMW OF NORTH AMERICA, INC.

In area (1) set ten 6.8 mm dia. holes for blind rivets N1.

Installation note: 

In area (2) 2 N5 punch rivets are used later.

Fig 2: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) and (2) set 6.8 mm dia. holes for blind rivets N1:

• Area (1): 3 bore holes
• Area (2): 2 bore holes
  Fig 3: Identifying Rivet Areas

  Courtesy of BMW OF NORTH AMERICA, INC.

In area (1) set seven 6.8 mm dia. holes for blind rivets N1.

Installation note: 

In area (2) 1 N5 punch rivet is used later.

Fig 4: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) to (4) set 6.8 mm dia. holes for blind rivets N1:

Open welded connections in area (1).

• Area (1): 5 bore holes
• Area (2): 2 bore holes
• Area (3): 1 bore hole
• Area (4): 9 bore holes

Installation note: 

After adhesive has hardened install 2 EMC SCREWS  in areas (1) and (4).

Fig 5: Identifying Rivet Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Set two 6.8 mm dia. holes for blind rivets N1 in area (1).

Remove all new parts and deburr holes.

Fig 6: Identifying Carrier Support Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.