Preparation Of New Part

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Open welded connections in areas (1).

Take off holder.

Fig 1: Identifying Welding Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in accordance with vehicle and cut.

Fig 2: Identifying Severance Cut

Courtesy of BMW OF NORTH AMERICA, INC.

Open welded connections on holder (1) by grinding with a belt grinder from inside.

Take off holder (1).

NOTE:

The inside surfaces of the engine support must be smooth. If necessary, surface-grind existing raised areas.
Belt grinder, see Aftersales Assistance Portal (ASAP)
Service/Technology - Workshop Equipment - Start BMW

Or at: www.bmwbroup-wep.com

Fig 3: Identifying Holder
Courtesy of BMW OF NORTH AMERICA, INC.

Adjust new part to fit with alignment bracket or universal mount.

Drill hole (1) at side.

Take hole position from repair element.

Hole diameter 12 mm

Remove new parts.

Fig 4: Identifying Drilling Hole

Courtesy of BMW OF NORTH AMERICA, INC.