1.3 ARC Welding And Brazing

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The extremely bright arc during welding may cause serious injury to the eyes if appropriate protective measures are not taken.

Use a special welding screen* for the relevant welding method (MAG or MIG).
Partition off the workbays with beam protection screens*.
Use a welding-emissions extractor facility*.
The welder must wear protective clothing* and gloves* which are suitable for welding (i.e. flame-proof).
A fire extinguisher must be located within reach of the welding area.
Do not carry out any welding work in the proximity of a fuel tank e.g. when it is installed.
Note national regulations.
*Sourcing reference, see Aftersales Assistance Portal (ASAP) - Service/Technology - Workshop Equipment (Start BMW) - Shop Workshop Equipment or at www.bmwgroup-wep.com or Service Information 5 01 00 532.