LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2014 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3036 (COLLISION - BODY PANEL REPAIR (E90) 328i, 328xi, 335i, 335xi) >> 4100 Body Panel Repair General Information >> 4100... Notes On Adhesive K3 >> Preparing The Glue Cartridge

Preparing The Glue Cartridge

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.

Do not prepare the glue cartridge until just before applying the adhesive. 

The working temperature of glue cartridge must be at least 18°C.

Pot life of adhesive is approx. 10 minutes at 25°C.

Insert glue cartridge into cartridge gun, remove cap and allow both adhesive components to emerge. Strip adhesive components uniformly and attach mixing tube. Only use mixing tubes supplied with glue cartridge.

Before starting to apply adhesive, allow approx. 1 mixing tube length of mixed adhesive to emerge. Only then apply the mixed adhesive to one side of the bonding surface.

Opened cartridges may be used again before the expiry date as long as a new mixing tube is used.

scientia non olet · About LEMON Manuals