Recommended Tools And Equipment
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2011 BMW 328xi, 2011 BMW 328i, 2010 BMW 335xi, 2010 BMW 335i, and 2010 BMW 328xi. However, it is still accessible from the selected car via links, so may be relevant.
- Blind riveting tongs
- Rivet head extension
Sourcing reference via Aftersales Assistance Portal (ASAP) - Service/Technology - Workshop Equipment (Start BMW) - Shop Workshop Equipment or at www.bmwgroup-wep.com.
Setting blind rivets:
- Refer to repair instruction for rivet size.
- Position bore holes for blind rivets as specified in repair instruction. If necessary, carry over the positions of the rivets to the new component.
- Drill holes (0.2 mm bigger than the outside diameter of the rivet. Example 4.2 mm dia. for 4 mm rivet and 6.7 mm dia. for 6.5 mm rivet).
- Deburr holes.
- APPLY ADHESIVE .
- Insert blind rivet. If necessary, remove adhesive that has emerged.
Position blind rivet tool vertically. Use rivet head extension if accessibility is poor.
- Rivet blind rivet with blind rivet tool. In the meantime clean rivet head if fouled with adhesive. Risk of damage to rivet head by penetrating adhesive.
- Seal blind rivets with SEALANT D1 (risk of corrosion).
- Seal cavities after painting vehicle with CAVITY SEALANT (risk of corrosion).