51 24 325 Left Tension Spring For Rear Lid Removal And Installation Or Replacement

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

51 3 290 . See BODY EQUIPMENT - SPECIAL TOOLS .

Necessary preliminary tasks:

Remove rear light . See 63 21 180 REMOVING AND INSTALLING/REPLACING LEFT OR RIGHT REAR LIGHT .

WARNING: Support rear lid in fully opened position with suitable apparatus. Risk of injury.

Attach special tool 51 3 290 in tension spring (1) and pull towards rear.

Installation:

Reattach tension spring (1) in same position.

Fig 1: Pulling Tension Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Unhook tension spring (1) from rear lid hinge (2).

Fig 2: Unhooking Tension Spring From Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts on the tension spring must not be damaged or missing:

Plastic sleeve
Foam inlay in tension spring

Fig 3: Identifying Plastic Sleeve And Foam Inlay In Tension Spring
Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Semicircular rubber buffer (2) (from window repair kit) must be fitted to rear lid hinge (3) without end stop (1).

Stick semicircular rubber buffer (2) at spacing (A) on rear lid hinge (3).

Semicircular rubber buffer (2) must touch rear lid hinge (3) in

area (4) with rear lid open. A= 65 mm

Fig 4: Rubber Buffer And Rear Lid Hinge

Courtesy of BMW OF NORTH AMERICA, INC.