34 52 516 Removing and installing/replacing DSC control unit

Necessary preliminary tasks:

Release screws (1) and carefully remove control unit (2).

Necessary preliminary tasks:

Tightening torque 34 51 1AZ .

Observe all "Installation notes ."

Fig 1: Identifying Control Unit And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: The control unit must not be positioned with force!
The two pins (2) must not be bent under any circumstances!

Installation note:

Carefully insert control unit (1) in direction of arrow, paying attention to the two pins (2).

Fig 2: Inserting Control Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Tightening sequence (1-4) must be observed.

Tightening torque 34 51 1AZ .

Fig 3: Tightening Sequence Of Electronic Stability Control Unit Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: