41 11 028 Left Engine Carrier Replacement (Partial Replacement Before Front Axle)

Place vehicle on straightening bench.

Following new body parts are required:

• Partial section, engine carrier
  Fig 1: Identifying Engine Carrier

  Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in accordance with measurement a and cut engine carrier completely.

Measurement a = approx. 35 mm from edge of diagonal strut.

Open weld joints in area (2) on inside and outside of engine carrier.

Fig 2: Identifying Mark Severance Cut In Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joint in area (1) and remove sheet.

Installation information: 

The joint is no longer developed for reasons of accessibility.

Weld in reinforcing plate approx. 40 mm long.

Fig 3: Identifying Weld Joint Area In Sheet

Courtesy of BMW OF NORTH AMERICA, INC.

Preparation of new part: 

Mark severance cut in accordance with measurement a (1) and cut completely.

Measurement a = approx. 200 mm from baffle plate.

Open weld joints in area (2) on inside and outside of engine carrier.

Installation: 

Adjust new part to fit with straightening attachment or universal mount.

Fig 4: Identifying Mark Severance Cut And Weld Joints Area

Courtesy of BMW OF NORTH AMERICA, INC.