51 71 447 Removing and installing/replacing trim panel for cover on frame side member (left or right)

Special tools required:

Necessary preliminary work:

Release screws (1) at front of wheel arch.

Fig 1: Identifying Wheel Arch Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivet (1) at front (A) and rear (B).

Installation note:

Replace defective expanding rivet (1).

Fig 2: Identifying Expanding Rivets

Courtesy of BMW OF NORTH AMERICA, INC.

Release expander rivets (1) on rear of trim panel (2) for frame side member.

Installation note:

Replace expanding rivets (2).

Fig 3: Identifying Expander Rivets On Rear Trim Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1) along bottom of trim panel for frame side member (2).

Installation note:

Clip (1) must be installed with seal.

Fig 4: Locating Trim Panel Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out top front of trim panel for frame side member (1) at entrance with special tool 00 9 325 .

NOTE: Considerable effort is required to lever out the panel.

Fig 5: Removing Trim Panel Top Front For Frame Side Member At Entrance With Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out top rear of trim panel for frame side member (1) at entrance with special tool 00 9 325 .

NOTE: Considerable effort is required to lever out the panel.

Fig 6: Removing Trim Panel Top Rear For Frame Side Member At Entrance With Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip trim panel for frame side member (3) and detach.

Installation note:

Clips (1) and (2) must not be damaged or missing. Seal must be installed.

Clip (1) = black

Clip (2) = white

Replacement

Fig 7: Locating Trim Panel Clips

Courtesy of BMW OF NORTH AMERICA, INC.