41 00... Installing A Cavity Bulkhead (Not Expanded)
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Carry over schematic representation to the relevant vehicle type.
The following repair represents replacement of a cavity bulkhead.
Before these work steps, prepare the new part so that it is ready to install (adapting, cutting to size, applying welding primer etc.).
Sand contact surface of cavity bulkhead (1) with coarse-grained abrasive paper (grain 50 - 100).
Clean contact surface (1) with spirit.
Apply an approx. 15 mm high bead of original BMW window adhesive to contact surface (1).
Attach cavity bulkhead in specified position (see old part).
Fit, secure and weld up new part.
WARNING:
Ensure adequate ventilation over entire processing period.