41 00... Stamping Vehicle Identification Number

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE: If the stamped vehicle identification number is removed during repair work, it must be stamped in again.
Read and comply with GENERAL INFORMATION .

Necessary preliminary tasks:

Remove FRONT RIGHT SPRING STRUT

Special tool kit 41 1 090 for stamping vehicle identification number consists of:

Guide plate 41 1 091

Counter-plate 41 1 092

Fig 1: Guide Plate (41 1 091) And Counter-Plate (41 1 092)

Courtesy of BMW OF NORTH AMERICA, INC.

Position counter-plate 41 1 092 at bottom on spring strut support plate.

Position guide plate 41 1 091 at top on spring strut support plate and secure.

IMPORTANT: Do not damage the spring support in the marked areas when positioning the guide plate.

Fig 2: Guide Plate (41 1 091)

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The illustration is a schematic representation and is to be applied to the relevant vehicle type.

Insert punch numbers 41 0 000 (1) individually into guide plate (2) and stamp vehicle identification number.

Fig 3: Punch Numbers (41 0 000) Into Guide Plate

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: In the event of component or body replacement by the workshops/garages, clearly delimit the vehicle identification number at front and rear by stamping a "+" in place of the BMW emblem.
Note national regulations.