31 21 180 Replacing Bearings (Wheel Hub) For Front Wheel

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Numbers and letters in text refer to numbers and letters in figures.

Release collar nut (1), press brake pedal to floor for this purpose.

Fig 1: Collar Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace collar nut. Tightening torque, 182 Nm.

IMPORTANT: Secure collar nut after tightening down on flattened area of drive shaft by peening.

Necessary preliminary tasks:

Remove brake disk. Refer to BRAKES - REPAIR INSTRUCTIONS - COOPER .
Remove wheel speed sensor

Release screws (1) and remove bearings for front wheel.

Fig 2: Removing Bearings

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tightening torque, 63 Nm.

IMPORTANT: Secure collar nut after tightening down on flattened area of drive shaft by peening.