52 26 000 Removing and installing/replacing left or right rear seat

Slide rear seat forward as far as it will go.

Tilt backrest forwards.

Release screws (1).

Installation note:

Replace screws.

Tightening torque 52 26 6AZ .

Fig 1: Identifying Screws

G11009101

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off cover (1) on left and right forwards.

Fig 2: Pulling Out Cover From Left And Right Side

G11009102

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining lugs (1) must not be damaged.

If necessary, replace faulty cover.

Fig 3: Identifying Retaining Lugs

G11009103

Courtesy of BMW OF NORTH AMERICA, INC.

Slide rear seat backwards as far as it will go.

Release screws (1).

Installation note:

Replace screws.

Tightening torque 52 26 6AZ .

Fig 4: Identifying Screws

G11009104

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Cover entrance for protection purposes (risk of damage).
Lift out front seat.