51 14 110 Removing and installing/replacing rear model designation
IMPORTANT:
The INSTRUCTIONS FOR ADHERING BADGE EMBLEM serve as the basis for these repair instructions and must be followed without fail.
Installation dimensions:
Mark position of model designation with adhesive tape using dimensions (A and B).
Position model designation on mark and stick on.
| A | B | |
|---|---|---|
| One | 111 mm | 78 mm |
| Cooper | 111 mm | 64 mm |
| Cooper S | 111 mm | 77 mm |
| Cooper D | 111 mm | 85 mm |
| Cooper SD | 125 mm | 81 mm |
Mark position of model designation with adhesive tape using dimensions (A to C).
Position model designation on mark and stick on.
| A | 95 mm |
|---|---|
| B | 138 mm |
| C | 93 mm |