11 13 000 Removing and installing, sealing or replacing oil sump (N14)

Special tools required:

Necessary preliminary tasks:

Drain ENGINE OIL .
Protect exhaust system against oil contamination and cover with suitable materials, clean if required.

Unscrew oil sump bolts in area of line (1).

Tightening torque 11 13 2 AZ .

Fig 1: Identifying Sump Bolts Line Area

Courtesy of BMW OF NORTH AMERICA, INC.

Remove bolt (1) above exhaust manifold using special tools 11 9 582 and 11 9 581 .

Fig 2: Removing Bolt Above Exhaust Manifold Using Special Tools (11 9 582) And (11 9 581)

Courtesy of BMW OF NORTH AMERICA, INC.

Clean sealing surface (1) with special tool 11 4 470 .

Fig 3: Identifying Sealing Surface

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not remove sealing bead itself.
Use a sharp knife to remove only the protruding or sticking-out parts of sealing beads (1).

Installation note:

Apply liquid gasket thinly and evenly.

Fig 4: Identifying Sealing Beads

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.