11 51 000 Removing and installing/replacing coolant pump (N16)
WARNING:
Risk of scalding.
Only perform these tasks on an engine that has cooled down.
Only perform these tasks on an engine that has cooled down.
Recycling:
Catch and dispose of drained coolant.
Observe country-specific waste disposal regulations.
Installation note:
- All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
- Retaining elements on chassis and suspension and steering parts must be replaced.
Necessary preliminary tasks:
- Remove FRICTION GEAR .
Release screws (1).
Remove coolant pump (2) downwards.
Installation note:
Replace gasket.
Clean sealing surfaces.
Assemble engine.
Bleeding instructions must be observed without fail. See VENT COOLING SYSTEM AND CHECK ON WATERTIGHTNESS or BLEED AND FILL COOLING SYSTEM WITH VACUUM FILLING UNIT .