Removal & Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 MINI Cooper, 2007 MINI Cooper, 2006 MINI Cooper, 2005 MINI Cooper, and 2004 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Do not allow any dirt to enter the system. Seal off line connections with plugs. If necessary, remove fan for power steering. Draw hydraulic fluid out of tank. Release plug connector (1) and pull off. Disconnect plug connection (2) in straight direction, otherwise damage may be caused. See Figure .

Release screw (1) and disconnect pressure line. Remove hose clamp (2) and detach return line. During installation, replace hose clamp. See Fig 1 .

Fig 1: Releasing Screw & Removing Hose Clamp

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten screws (1). See Figure .

Slacken nut (1). Replace self-locking-nuts. Remove power-steering pump (2) with bracket. See Figure .

When replacing power steering-pump, release nuts (1) on al1 four rubber mounts. Release screws (2) and remove rubber mounts (3). Replace damaged rubber mounts (3). See Figure . Bleed power steering system. See BLEEDING .