51 13 102 Removing and installing/replacing cover on front left or right wheel arch

If necessary, release clip on front wheel arch cover (1).

Bend wheel arch panel (1) inwards slightly and release clip (2).

Installation note:

If necessary, replace faulty clip (2).

Fig 1: Bending Wheel Arch Panel Inwards

Courtesy of BMW OF NORTH AMERICA, INC.

Feed cover (1) in area (A) towards front out of bumper.

Release cover (1) from clips (2); if necessary, disconnect associated plug connection and remove.

Installation note:

If necessary, replace faulty clips (2).

Fig 2: Releasing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

If replacing with USA national version: