51 13 085 Removing and installing/replacing trim strip on engine hood/bonnet (cowl panel)

IMPORTANT: Risk of damage.
Do not bend trim strip (1) and chrome strip (2) during removal.

Carefully detach trim strip (1) in direction of arrow from hood/bonnet.

NOTE: To remove, if necessary tape off hood/bonnet with adhesive tape and remove trim strip (1) with a suitable tool.

Fig 1: Detaching Trim Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Make sure chrome strip (2) is correctly seated on trim strip (1), reinstall chrome strip (2) if necessary.

Pay attention to center marking on trim strip (1) and hood/bonnet.