51 22 010 Replacing top clubdoor detent (striker)

Pull off striker cover (1).

If necessary, detach mucket (3) in working area.

Installation:

Retaining lugs (2) must not be damaged.

Make sure mucket (3) is correctly seated.

Fig 1: Identifying Striker Cover, Retaining Lugs And Mucket

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove cover (2).

Fig 2: Identifying Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove door detent (2).

Tightening torque 51 22 1AZ .

Installation:

Labelling (3) of striker must point in direction of travel.

Fig 3: Identifying Door Detent, Screws And Labeling

Courtesy of BMW OF NORTH AMERICA, INC.