51 16 060 Removing and installing or replacing inside mirror

Version with remote key for central locking system:

If necessary, disconnect negative lead from BATTERY .

Version with compass:

Check compass function if replacing or after disconnecting inside mirror plug connection or battery.

If necessary, CALIBRATE COMPASS IN INTERIOR REARVIEW MIRROR .

IMPORTANT: To avoid windscreen breakage:
Snap out (press) inside mirror only in direction of travel towards windscreen.
Do not under any circumstances twist the mirror base when removing.
Twisting the inside mirror off the mirror base will damage the rear catch.
If the rear catch is damaged, the inside mirror will be loose when installed and must be replaced.

Separate end caps (1) in direction of arrow from each other.

Turn inside mirror (2) and remove end caps (1).

Fig 1: Separating End Caps From Each Other

G04797493

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1 and 2) of end caps (3) must not be damaged, replace if necessary.

Fig 2: Identifying End Caps With Latch Mechanisms

G04797494

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage.
Do not snap inside mirror (1) out of mirror base by turning.

Snap out inside mirror (1) from mirror base towards front with increasing pressure (not abruptly) and remove.

Fig 3: Snapping Out Inside Mirror From Mirror Base

G04797495

Courtesy of BMW OF NORTH AMERICA, INC.

Version with cable (X):

Disconnect plug connection (1) and remove inside mirror (2).

Fig 4: Identifying Inside Mirror And Plug Connection

G05516878

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Twist mirror foot by approx. 45° and fit to mirror base.
Turn mirror base until it engages on mirror mount.

Fig 5: Twisting Mirror Foot By 45 Degrees

G04797496

Courtesy of BMW OF NORTH AMERICA, INC.

Only replace with version with remote key for central locking system:

Initialize all transmitters (ignition keys), refer to Vehicle Owner's Handbook.