52 13 000 Removing and installing driver's or front passenger seat (normal/manual)

WARNING: Observe safety regulations for handling AIRBAG MODULES AND PYROTECHNICAL SEAT BELT TENSIONERS .

Incorrect handling may trigger off pyrotechnical belt tensioners or the side airbag, which may result in injury.

Necessary preliminary tasks:

Switch off ignition
Disconnect BATTERY NEGATIVE LEAD

Slide front forward as far as it will go.

Release screws (1).

Installation:

Replace screws and insert with Loctite.

Tightening torque 52 13 1AZ .

Fig 1: Identifying Front Seat Screws

G04797737

Courtesy of BMW OF NORTH AMERICA, INC.

Slide front seat back as far as it will go.

Release screws (1).

Installation:

Replace screws and insert with Loctite.

Tightening torque 52 13 1AZ .

Unlock plug connections (2) and disconnect plug (3).

Fig 2: Identifying Screws And Plug Connections

G04797738

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Cover entrance for protection purposes (risk of damage).
Lift out front seat.

Installation:

Carpet must not get between seat rails and floor pan near screw-fastening points (grating noises).