51 47... Removing and installing/replacing cover on inside left entrance

Release screw (1).

Installation:

Replace screw and insert with Loctite.

Tightening torque 72 11 4AZ .

Fig 1: Identifying Inside Left Entrance Cover Screw

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, remove floor mat.

Release mucket (1) in area of side trim panel (2) and cover (3).

Unclip side trim panel (2) from cover (3).

Pull side trim panel (2) inwards slightly and release cover (3) from clips (4).

Feed cover (3) in direction of arrow out of guides (5).

Fig 2: Removing Cover From Guides

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Guides (1) and clips (2) on cover (3) must not be damaged.

Fig 3: Identifying Guides, Clips And Cover

Courtesy of BMW OF NORTH AMERICA, INC.