51 14 012 Removing and installing/replacing rear MINI badge (on left splitdoor)
IMPORTANT:
The instructions for number/letter combination cementing serve as the basis for these repair instructions and must be followed without fail. See ATTACHING NUMBER/LETTER DESIGNATION COMBINATION and COMPONENT BONDING WITH ADHESIVE TAPE .
Mark position of MINI badge (1) with adhesive tape according to measurements (A and B).
A = 43 mm
B = 36 mm
Pull liner* off MINI badge (1).
Position MINI badge (1) horizontally on marking and stick on.
*Liner is the protective film on the new MINI badge.