41 62 010 Removing and installing left splitdoor

Read contents of BODY, GENERAL .

Necessary preliminary tasks:

Release holder (1) in direction of arrow and carefully pull out.

Fig 1: Releasing Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect both plugs (1) and detach plug from holder (2).

Fig 2: Identifying Holder And Plugs

Courtesy of BMW OF NORTH AMERICA, INC.

Release wiring harness (1) from body and carefully feed out.

Installation:

Make sure wiring harness is correctly seated (watertightness).

IMPORTANT: Secure door against falling out.

Fig 3: Identifying Wiring Harness

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws and pull out of hinges.

Tightening torque 41 62 1AZ .

Remove door.

Installation:

If necessary, ADJUST DOOR .