41 32 000 Replacing left or right cowl panel (partial replacement before roof connection)

Read contents of BODY, GENERAL .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved SPOT-WELDING APPARATUS for repairs.

NOTE: Picture shows R56.

The following new body parts are required:

Fig 1: Identifying Outer Side Frame

Courtesy of BMW OF NORTH AMERICA, INC.

CAUTION: Cut outer plate only for following severance cuts.

Water drain pipe of panorama roof is located behind severance cuts a and b.

Mark severance cut in accordance with dimension and cut.

Dimension a = 60 mm below bore dia. 8 mm.

Dimension b = 50 mm above bore dia. 8 mm.

Open weld joints in areas (1).

Fig 2: Identifying Severance Cut Mark And Welded Connections Area

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Remove cavity acoustic baffle under cut (1) through opening in cowl panel.

Installation:

Mark new part in accordance with severance cuts above and cut.

Weld in REINFORCEMENT PLATES at severance cuts.

Fig 3: Identifying Cavity Acoustic Baffle Under Cut Mark

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Apply CAVITY FOAM through bore hole (1) in inner A-pillar.

Fig 4: Identifying Cavity Foam Application Area

Courtesy of BMW OF NORTH AMERICA, INC.